p.
3
- M
an
u
al
FA
0
1
07
8
-E
N
- 0
2
/2
0
18 © C
A
M
E S
.p.
A
. - T
ra
n
sl
ati
on of th
e o
rig
in
al
in
str
u
cti
on
s
• All maintained-action switches that are connected to the control panel must be po-
sitioned so that the maneuvering area is completely visible from the switches, yet far
enough away from any moving parts. • Make sure that the operator has been properly
adjusted and that any associated safety and protection devices, as well as the gearmo-
tor's manual release, are working properly. • If the power-supply cable is damaged, it
must be replaced by the manufacturer or by the licensed technical-assistance center or
by duly trained, skilled staff, to prevent any risks. • During all phases of the installation
make sure you have cut off the mains power source. • The electrical cables must run
through corresponding tubes or conduits to ensure suitable protection against mecha-
nical damage and they must not come into contact with parts that could heat up during
use. • Make sure you have set up a suitable dual pole cut off device along the power
supply that is compliant with the installation rules. It should completely cut off the power
supply according to category III surcharge conditions. • If the control panel is used for
automating guided parts in residential settings, permanently fit the entrapment-hazard-
warning signage, so that it is clearly visible or close enough to all command and control
devices. After installing, make sure that the operator is properly adjusted and that the
guided part, in case it touches any object that is 50 mm high off the ground, reverses
its movement or that the object may easily be removed (for operators that have built-in
anti-entrapment systems that depend on coming into contact with the lower edge of
the guided part). Also make sure that the guided part does not extend onto any public
pedestrian passages or onto the street. • Store this manual inside the technical folder,
along with the installation manuals of the other devices in the system. Remember to
hand over to the end users all the operating manuals of the products that make up the
final machinery.
