7
- FA01713M4A
- 10/2022 © CAME S.p.A.
Description
806SL-0300
SELR1BDG - External BUS CXN transponder selector for keycards, key fobs and TAG (Manchester
protocol) with blue backlighting. Grey colour RAL7024.
Technical data
MODELS
SELR1BDG
Power supply (V - 50/60 Hz)
12 - 24 AC - DC
BUS connection (CXN Unit)
1
Power (W)
0.35
Absorbed current (mA)
25
Operating temperature (°C)
-20 ÷ +55
Storage temperature (°C)*
-25 ÷ +70
Protection rating (IP)
54
Frequency (kHz)
125
Insulation class
III
Average life (cycles)**
500000
(*) Before installing the product, keep it at room temperature where it has previously been stored
or transported at a very high or very low temperature.
(**) The average product life is a purely indicative estimate. It applies to compliant usage,
installation and maintenance conditions. It is also infl uenced by other factors, such as climatic and
environmental conditions.
Description of parts
A
1
Front cover
2
Transponder
3
Board protection cover
4
Rubber gasket
6
External gasket
7
External casing
Control board
B
8
Set-up DIP switch
9
Terminal block
10
Status warning LED
Size
C
Installation
D
Connections and settings
E
For systems with more than one selector, please check the control panel or operator
manual for information on the diff erent types of wiring.
①
BUS confi guration
We recommend using a FROR 2x1mm² cable, maximum length from the control board:
50 m.
Do not use a shielded cable.
Connect the selector to the BUS terminal on the control panel.
Up to 7 BUS selectors can be connected (keypad, transponder, Bluetooth or key).
If there are multiple BUS selectors connected in the system, set a diff erent address for each
selector using DIPs 1 2 3.
If two selectors have the same address on the BUS, the backlighting fl ashes red to
highlight the confi guration error.
②
Configuring R700 V2 / S0002P
We recommend using a FROR 2 x 1 mm cable, maximum 30 m in length from the
control board.
Connect the selector to terminals S1-GND on the electrical panel.
Set DIP 1 2 3 to OFF.
Interface board
Number of selectors that can be
connected
R700
1
R700 V2
2
S0002P
4
Backlighting
Set DIP 4 to ON to activate the selector backlighting.
When the device is in standby mode, the backlighting is blue.
Final operations
G
