FA01741M4A - 11/2021
FA01741M4A - 11/2021
⚠
You cannot simultaneously connect the flashing lights to the
24 V AC/DC and
⑭
230 V AC inputs
⑮
.
Connection to the control panels.
C
⚠
Always connect the LAMP terminal to the W-E1 terminals on
the 230 V panels
C
⑪
or the 10-E input of the RIOCT8WS to
terminals 10-E or 10-E1 of the 24 V control panels
C
⑫
.
☞
Always enable the pre-flashing.
☞
Enable the services test (if present).
☞
Generally avoid those conditions in which when the operator
is idle the flashing light is active.
For example, with function C4 enabled on the CAME panel, if the
photocell is engaged, the RIO accessories shall remain active for
the entire intervention period, thus reducing battery life.
RESETTING procedure
Keep the RESET button pressed for 10 seconds, until the WIRELESS
LEDs start flashing.
N.B.: If you replace any device on the system, you will have to
RESET and then again SAVE all of the system devices.
Functional checks
Issue a start command (each RIO accessory will flash * blue)
Make sure that the RIOLX8WS activates.
Obstruct the gate's action and check whether the RIOPH8WS and/
or RIOED8WS devices actually activate the prescribed safety func-
tion.
When the maneuver is complete, each RIO accessory will flash* red
and switch into LOW POWER mode to preserve the batteries.
⚠
In LOW POWER mode, the photocells will respond more slow-
ly - the LED flashes blue - to the manual operation test.
* If this does not happen, cut off the mains power supply and
increase the radio signal's range/power by setting the jumper
E
⑤
to position H.
Troubleshooting
Alerts
Possible causes
Fix
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
TS terminal (safety
test) not connected.
Connect the TS termi-
nal (or 2, is missing) to
the corresponding one
on the control panel.
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
No Rio accessory is
memorized.
Configure RIO acces-
sories.
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
The photocells:
a. detect an obstruc-
tion;
b. are misaligned;
c. have flat batteries.
a. Remove the
obstruction.
b. Align the photo-
cells.
c. Replace the
batteries.
LED stays on,
LED is off,
LED flashes
Buzzer active
