CAME G4140ZU, Installation Manual

Page: 25 / 32

Pa
g.
25
- M
an
ua
l c
od
e:
11
9G
V2
9
v
er
.
2.
0
0
9/
20
10 © C
AM
E c
an
ce
lli a
ut
om
at
ic
i s
.p
.a
. -
Th
e d
at
a a
nd i
nf
or
m
at
io
n r
ep
or
te
d i
n t
hi
s i
ns
ta
lla
tio
n m
an
ua
l a
re s
us
ce
pt
ib
le t
o c
ha
ng
e a
t a
ny t
im
e a
nd w
ith
ou
t o
bl
ig
at
io
n o
n C
AM
E c
an
ce
lli a
ut
om
at
ic
i s
.p
.a
. t
o n
ot
ify u
se
rs
.
9 Safety instructions
This product must only be employed for its originally intended use. The automation installation using these gearmotors requires
adequate safety systems on the gate leaves to detect any obstacles (e.g. sensitive edges), in compliance with UL325 standards
and CSA C22.2 No. 247 for both US and Canada. Any other use is wrong and potentially dangerous.
The manufacturer cannot be held liable for any damages resulting from wrongful, erroneous or negligent uses.
Avoid using near mechanical moving parts. Stay out of the opening/closing arc when operator is in motion.
Do not exercise force against the motion of the operator as this could result in potentially dangerous situations.
Do not allow children to play or loiter within the opening/closing arc of the operator. Keep remote controls and any other command
dev ice out the reach of children, to prevent operator from being activated by accident.
In the event of anomalous behaviour, stop using the operator immediately.
Danger of crushing hands Danger! High voltage
No transit during operation
Important safety instructions
10 Maintenance
10.1 Periodic maintenance
Periodic maintenance to be carried out by the end-user is as follows: wipe clean
the glass surface of the photocells; check that the safety devices work properly; remove any
obstruction.
We suggest checking the state of lubrication and tightness of the anchoring screws on the
operator.
-To check the efficiency of the safety devices, move an object in front of the photocells when
gate is closing. If the operator inverts the motion or stops, the photocells are
working properly.
This is the only maintenance procedure to be bar out with the power source connected.
-Before performing any maintenance procedures, cut off the main power, to prevent possible
accidents due to bar movement.
-To clean the photocells use a water dampened cloth. Do not use solvents or other
chemical products which may ruin the devices.
-Make sure there are no plants within the photocell’s beam, and that the bar motion is free of
any obstacles.