CAME G2080EZ, Installation And Operation Manual

Page: 61 / 128

p.
2
9
29
- M
an
u
al
c
od
e:
F
A
0
1
0
3
8
-E
N
FA
0
1
0
3
8
-E
N
v.
11
- 0
1/
2
0
18 - © C
am
e S
.p.
A
. - T
h
e m
an
u
al
's c
onte
nts m
ay b
e e
d
ite
d at a
ny ti
m
e w
ith
ou
t n
oti
ce
.
TROUBLESHOOTING
PROBLEM REFERENCE CHECK
The boom neither opens nor closes 1-2-3-4-6-8-
13-18 1 - Lock the inspection hatch with the key
The boom opens but does not close 4-7 2 - Deactivate the MAINTAINED ACTION function
The boom closes but does not open 4-7-12-13 3 - Check the power supply and fuses
The barrier does not perform automatic closing 11-12-13 4 - The NC contacts are open
The barrier does not work with the transmitter 2-14-16 6 - Deactivate the MASTER-SLAVE function
The boom's direction of travel is inverted 7-18 7 - Check the boom's balancing and spring tautness
Only one transmitter works 22 8 - Deactivate the OBSTRUCTION DETECTION function
The photocells do not work 12-23-24 11 - Activate the AUTOMATIC CLOSING function
The warning LED flashes quickly 4 12 - Check the proper direction of travel
The warning LED stays lit 13 13 - Check the control devices
The boom does not reach the endstop 7 14 - Replace the AF card
The boom cannot be balanced 7-15 15 - Check the length ration between boom and applied
accessories
The barrier does not slow down 7-15 16 - Memorize the radio code again
The barrier does not work with emergency batteries 8-25-26 18 - Adjust the sensitivity
The boom starts slow 7 22 - Enter or duplicate the same code on all transmitters
23 - Activate the photocells
24 - Connect the photocells serially instead of in parallel fashion
25 - Check the batteries
26 - Respect the photocell's power supply polarities
Er1 The boom travel calibration was interrupted by the activation of the STOP button.
Er3 Encoder is broken.
Er4 Services test error.
Er5 Insufficient working time
Er6 Maximum number of obstructions detected.
Er7 Transformer overheating.
Er8 The inspection hatch is open.
C0 Contact 1-2 (NC) is open.
C1, C4, C5 or C9 The (NC) contacts are open.
The warning LED
flashes The control board is not yet calibrated for the boom travel.
ERROR MESSAGE

The error messages appear on display and are notified by LEDs
.