Page
27
- Manual
FA02036-EN
- 12/2023 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Radio decoding
Choose the type of radio coding for the transmitters enabled to control the operator.
If you choose the type of radio coding for the transmitters [Rolling code] or [TW key block], any transmitters with a different type of radio coding saved previously
will be deleted.
U4
1 = All decoding (default)
2 = Rolling code
3 = TW key block
Self-Learning Rolling
Save a new rolling code transmitter by activating acquisition from a rolling code transmitter that has already been saved. The saving and acquisition procedures are
explained in the transmitter manual.
U8
OFF (Default)
ON
Motor type
Set the type of gearmotor installed.
A1
1 = 400 kg
2 = 600 kg
3 = 800 kg
4 = 1000 kg
Travel calibration
Start the travel self-learning.
This function appears only if the [Encoder] function is active.
A3
OFF (Default)
ON
Parameter reset
Restore factory settings except for the functions: [Radio decoding], [Motor type] and the settings related to travel calibration.
A4
OFF (Default)
ON
Manoeuvre counter
View the number of operator manoeuvres.
A5
001 = 100 manoeuvres
010 = 1000 manoeuvres
100 = 10000 manoeuvres
999 = 99900 manoeuvres
CSI = Maintenance work
Adjusting the motor torque
Adjust the motor torque.
A6
From 1 (minimum) to 5 (maximum)
FW version
Display the firmware version number and the GUI installed.
H1
