CAME BXV Series, Installation Manual

Page: 55 / 144

TX 2 TX 2 10 2 TX C
-
+
-
NC
M N
+ E -
FC FA F
10 TS 2 CX CY 1 2 3P 7
DFWN
M N
+ E -
FC FA F
10 TS 2 CX CY 1 2 3P 7
L N
E1 EX W
24V 0
M N
+ E -
FC FA F
10 TS 2 CX CY 1 2 3P 7
L N E1 EX W
24V 0
L1T L2T CT
VS
VF
U
V
W
CA
PAC
ITO
R
L N
E1 EX W
24V 0
L1T L2T CT
VS
VF
U
V
W
CA
PAC
ITO
R
10 11 E 5 24 0
DELTA-S DIR
TX 2 + - + - NO C
-
NC
M N
+ E -
FC FA F
10 TS 2 CX CY 1 2 3P 7
DELTA
RX
RX
TX
TX
p.
19
- M
an
ua
l
FA
010
04
-E
N
- 0
1/
20
18 - © C
AM
E S
.p
.A
. - T
ra
ns
la
te
d o
rig
in
al i
ns
tru
ct
io
ns
SAFETY DEVICES
Photocells
Configure contact CX or CY (NC), safety input for photocells.
See CX input functions (Function F2) or CY (Function F3) in:
- C1 reopening during closing. When the gate is closing, opening the contact triggers the inversion of movement
until the gate is fully open again;
- C2 close back up during opening. When the gate is opening, opening the contact triggers the inversion of
movement until the gate is completely closed.
- C3 partial stop. Stopping of the gate, if it is moving, with consequent automatic closing (if the automatic closing
function has been entered);
- C4 obstruction wait. Stopping of the gate, if it is moving, which resumes movement once the obstruction is
removed.

If contacts CX and CY are not used they should be deactivated during programming.
Sensitive Safety Edges
Configure contact CX or CY (NC), safety input for sensitive safety-edges.
See CX input functions (Function F2) or CY (Function F3) in:
- C7 reopening during closing. When the gate is closing, opening the contact triggers the inversion of movement
until the gate is fully open again;
- C8 reclosing during opening. When the gate is opening, opening the contact triggers the inversion of movement
until the gate is fully closed.

If contacts CX and CY are not used they should be deactivated during programming.
DFW with control board of the DFI
connections