beep
beep
beeeep
5),'
352*
²
0
352*
VA/01 - VA/08
VA/01 - VA/08
Page
7
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
7
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
7
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
To delete the number codes relating to
a group, press , enter an access code
(4 to 8 digits long) associated with the
group, followed by key
.
If the code is valid, the
LED stays
constantly on and it is possible to con-
tinue with programming.
Press key , enter the access code
again and press key again to confi rm
the operation. A long beep will confi rm
the procedure was correct.
?
In the event of an error, this will be
indicated by 3 fast beeps. Repeat the
stage correctly.
To delete all the codes relating to a
group, enter the call code, or press the
call key associated with the group, fol-
lowed by key
.
If the code is valid, the
LED stays
constantly on and it is possible to con-
tinue with programming.
Enter the call code again, or press the
call key associated with the group, fol-
lowed by key
. A long beep will
confi rm the procedure was correct.
?
In each of the two stages of de-
letion any error condition will be sig-
nalled by three fast beeps. Repeat the
stage correctly.
Deleting number codes
Put the RFID PROG jumper in the “–”
position. The PROG LED on the power
supply and the
and
LEDs will fl ash
slowly
and
.
