PROG
PROG
PROG
PROG
>3 s
>3 s
<6 s
<6 s
>3 s
>3 s
VA/01
VA/01
MTMA/01
MTMA/01
MTMV/01
MTMV/01
beep
Page
3
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
3
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
3
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Press the door-release
and AUX2
keys and enter the group call code
(from 1 to 98) followed by key
:
The
call code is associated with the internal
receiver
and the call key chosen
.
Continue, repeating the same opera-
tions for all the other internal receivers.
The operation can only be carried out
from an entry panel with the
LED off .
?
To change the entry panel from
which to carry out call programming,
you must press key 1 followed by key
.
Programming the call codes
The
LED will fl ash to signal entry into programming
.
With VA/01
Press the PROG key until the PROG LED
lights up
.
With MTMA/01-MTMV/01 with-
out VA/01
Press the PROG key for at least 3 sec-
onds and release it within 6 seconds
.
PROGRAMMING CALL CODES AND DOOR-RELEASE CODES
?
This programming is available only with audio modules MTMA/01 and video modules MTMV/01.
Call programming associates a call code with each internal receiver.
Programming the door-release codes associates number codes with the relays present on audio module MTMA/01 or video
module MTMV/01. The control is local and where there is more than one audio module MTMA/01 and video module MTMV/01
carry out the door-release programming on each entry panel.
Going into Programming
