4
1. remove the #8 Pin-in-Torx screw from the column with a T-20 PIT driver bit.
2. slide the column out of the compartment and verify the rail positions at the
desired positions for your application.
3. Install two stainless steel rods (see image) through the small holes in each
of the lower tabs of the rails assembled to the column. additional rods can be
purchased and installed in the center positions for added security.
4. Verify that each rail tab has a rod threaded through its hole.
5. slide the completed assembly back into the compartment and re-install the
screw back into the original hole.
STEP 1
STEP 2
STEP 3
STEP 5
STEP 4
Step 1 - Remove the #8 Pin-in-Torx screw from
the column with a T-20 PIT driver bit.
Step 2 - Slide the column out of the compartment
and verify the rail positions at the desired
positions for your application.
Step 3 - Install two stainless steel rods (see image)
through the small holes in each of the
lower tabs of the rails assembled to the column.
Additional rods can be purchased and installed
in the center positions for added security.
Step 4 - Verify that each rail tab gets the rod through
the hole.
Step 5 - Slide the Completed assembly back into the
compartment and re-install the screw back into the
original hole.
D
C
B
A
A
B
C
D
1
2
3
4
5
6
7
8
8
7
6
5
4
3
2
1
E
F
E
F
E
CMBPSP Assembly view
REV
CMBPSP Assembly view
IV. Instructions for security Package (sP) Models
