2
Section I - Product Information
This unit is designed to heat plates up to a temperature of 80˚F (26�7) to 175˚F (79�4˚C)� It is equipped with self-leveling mechanisms that are calibrated
at the factory� The digital temperature displays will light up once either silo is turned on� The fan motor circulates the heated air around the plates in a
convection process that promotes an efficient and even heat absorption by the plates� Once the air inside the cabinet has reached the desired set-point
temperature, the digital controller will continue to maintain this temperature� To dispense plates use the Cambro Plate and Pellet Lifter (MDSPL) to safely
lift the plates from the unit�
The Cambro Plate Heater accommodates plates ranging from 9" (22,8 cm) to 10�5" (26,7 cm) diameter�
A protected circuit of the correct voltage and amperage must be available for connection of the line cord� Refer to your local electrical codes or the National Electrical
Code or refer to a qualified electrician to be sure the unit is connected to the proper power source�
Important Safeguards
WARNING: Electric shock hazard,
Unit must be grounded� Plug the supplied power cord into a properly grounded receptacle that matches the plug� Do not use any
adapter� Do not use an extension cord� Make sure receptacle is protected by a dedicated circuit breaker rated at 15 amps or higher�
DANGER: Electric shock hazard,
Turn main power switches on unit to the OFF positions and unplug the unit before servicing or performing any maintenance�
WARNING: Hazardous voltage inside.
Do not open back of cabinet� No user-serviceable parts inside� For service please call Cambro at 800-833-3003 x4118�
WARNING:
Adjustments and service work should be performed only by a Cambro qualified service technician� For service please call Cambro at 800-833-3003 x4118�
NOTICE:
This equipment is intended for Indoor commercial foodservice use only� Not for household use�
NOTICE:
Do not use any corrosive cleaners� Use only cleaners designed for stainless steel�
DANGER:
Keep hands and fingers away from the lid hinges (pinch point) located at the rear edge of each lid� Lift and close using the lid handles only, slamming or dropping the
lid or flipping open may cause damage or injury�
WARNING:
Temperature of plates inside silos may cause injury if handled directly�
Model
CHPL100
Description
Plate Heater
Number of Stacks
2
Capacity
100 plates (50 in each silo)
Overall Dimensions
Width
39 ¾” (100,97 cm)
Depth
26 ½” (67,31 cm)
Height
39 7/8" (101,28 cm)
Product Weight
355�5 lbs� (161,25 Kg)
Electrical Specifications
Voltage/Phase
208-240 VAC
Amperage
10�5
Watts
2400
Hz
50/60
NEMA Plug Configuration
6-20
Cord Length
6' (183 cm)
Factory Set Temperature
80˚F – 175˚F (26,7˚C – 79,4˚C)
Heat-Up Time
2 hours
Section II – Safety Precautions
