page 18
Qt Conference Room Edition Installation and Operations Guide
INSTALLATION
Flush mount with supplied box
Cut hole in wall to dimensions x by x (use template) and run cables to this hole. After the cables have
been run to the hole in the wall, place the flush mount box in the wall (make sure up is actually up) and
snap the four clips that clamp to the back side of the drywall surface. Then attach the case rear to the
wall adapter. During installation if may be convenient to attach the wires to the tie-off point in the back
of the box to prevent the wires from falling back into the wall.
Controller
Case back panel
Flush mount box
3
3
/
4
” x 7
1
/
2
” (95 x 190mm)
hole in wall
(See template on page 35)
4x control module
back panel screws
