TEMPERATURE
CONTROL
FLAME
FLAME
POWER
HEATER
II
HEATER
I
POWER
This fireplace is for use on 120 V outlets. The cord has a 3-prong plug (See Figure 4-A). An adapter is available
for connecting 3-prong grounded-type plugs to two-slot receptacles (See Figure 4-C). The green grounding
plug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded receptacle is not available.
8
Figure 4
Grounding Pin
Grounding Means
Cover of Grounded
Outlet Box
Metal Screw
A
B
C
Once the unit has been properly connected to a grounded electrical outlet, it is ready to operate.
Note:
Make sure the circuit breakers for the power supply are turned on.
•
Pilot Light for Heater: Pilot light goes on when heater is in use.
Note:
The Flame and Heating system are controlled by separate power switches and can work independent
from each other. The Flame system can be on while the Heating element is off and the Heating element
can be on while the Flame system is off. We suggest that you should turn the Flame system and Heating system
on at the same time when you turn on the electrical fireplace.
Figure 5
Temperature
Control Knob
Flame Adjust Knob
Power Switch
Heater Low Switch
Heater High Switch
Flame Power Switch
SECTION 4
OPERATING INSTRUCTIONS
4.1 GROUNDING INSTRUCTIONS
4.2 CONTROL PANEL OPERATING PROCEDURES
