Cambium Networks PTP 820C, Installation Manual

Page: 37 / 206

Chapter 2: Product Hardware Description Antenna Connection
phn-3962 004v000
Page 2-13
Antenna Connection
PTP 820C can be mounted directly for all frequencies (6 GHz - 38 GHz) using the following antenna
types (for integrated antennas, specific antennas part numbers are required):
•
CommScope: VHLP series
•
Radiowaves: HP series
•
Cambium Networks: CNT series
For remote mount installations, the following Flexible Waveguide flanges should be used
(millimetric). The same antenna type (integrated) as indicated above can be used (recommended).
Other antenna types using the flanges listed in the table below may also be used.
Table 9 Other antenna types
Frequency Circ. WG
Diameter Rect. WG
Flange Des. Radio Side
(Remote)
Flange Des. Flex WG
Side A
Flange Des. Flex WG
Side B
Flange Des. Antenna
(Remote)
Flange Des.
Band Range
(GHz)
6(L/U)
GHz 5.8-7.1 31.8 mm WR137 UDR70 PDR70 PDR70 UDR70
7/8 GHz 7.1-8.5 26 mm WR112 UBR84 PBR84 PBR84 UBR84
10/11
GHz 10.0-11.7 18 mm WR90 UBR100 PBR100 PBR100 UBR100
13 GHz 12.7-13.3 15 mm WR75 UBR120 PBR120 PBR120 UBR120
15 GHz 14.5-15.4 13.5 mm WR62 UBR140 PBR140 PBR140 UBR140
18 GHz 17.7-19.7 10.5 mm WR42 UBR220 PBR220 PBR220 UBR220
23 GHz 21.2-23.6 9 mm
26 GHz 24.5-26.6 8 mm
28-31
GHz 27.3-29.5 7 mm WR28 UBR320 PBR320 PBR320 UBR320
32 GHz 31.8-33.4 6.5 mm
38 GHz 37.0-40.0 5.5 mm
If a different antenna type (CPR flange) is used, a flange adaptor is required. Please contact your
Camibum Networks representative for details.