Chapter 6: Ethernet Services and Interfaces
Configuring Ethernet Service(s)
phn-3965_006v002
Page 6-7
1.
Select
Ethernet
>
Services
. The Ethernet Services page opens (
).
2.
Select the services in the Ethernet Services Configuration table, or select all the services by selecting the check
box in the top row.
o
To enable the selected services, in the Multiple Selection Operation section underneath the Ethernet
Services Configuration Table, select
Operational
and click
Apply
.
o
To disable the selected services, in the Multiple Selection Operation section underneath the Ethernet
Services Configuration Table, select
Reserved
and click
Apply
.
o
To delete the selected services, select
Delete
underneath the Ethernet Services Configuration Table.
Before deleting a service, you must delete any service points attached to the service, as described in
Figure 191
Multiple Selection Operation Section (Ethernet Services)
Note
When setting multiple services to
Reserve
state, make sure to avoid setting the management service
to
Reserve
state.
Viewing Service Details
To view the full service parameters:
1.
Select
Ethernet > Services
. The Ethernet Services page opens (
2.
Select the service in the Ethernet Services Configuration table.
3.
In the Ethernet Services page, click
Service Details
. The Ethernet Services
–
Service Details page opens. The
Service Details page contains the same fields as the Add page (
). However, in the Service Details
page, these fields are read-only.
Summary of Contents for PTP 820 Series
