Cambium Networks PTP 820 Series, User Manual, Page: 375 / 1149

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3965_006v002
Page 6-4
Table 61 Ethernet Services Page Parameters
Parameter Definition
Services ID A unique ID for the service.
Service Type The service type:
•
MP – Multipoint
•
P2P – Point-to-Point
•
MNG – Management
Service sub type Indicates the type of service ( Ethernet ).
EVC ID The Ethernet Virtual Connection (EVC) ID. This parameter does not affect
the network element’s behavior, but is used by the NMS for topology
management.
EVC description The Ethernet Virtual Connection (EVC) description. This parameter does
not affect the network element’s behavior, but is used by the NMS for
topology management.
Admin Indicates whether the service is enabled ( Operational ) or disabled
( Reserved ). You can configure services for later use by defining the
service as Reserved . In Reserved mode, the service occupies system
resources but is unable to transmit and receive data.
Adding an Ethernet Service
To add an Ethernet service:
1. Select Ethernet > Services . The Ethernet Services page opens ( Figure 189 ).
2. In the Ethernet Services page, click Add . The Ethernet Services – Add page opens.