Chapter 5: Radio Configuration
Configuring the IDU-RFU Connection (PTP 820F only)
phn-3965_006v002
Page 5-7
Configuring the IDU-RFU Connection (PTP 820F
only)
For PTP 820F, you must configure the following IDU-RFU connection parameters:
•
PoE Power
–
Certain RFU types can receive PoE power from the IDU when they are connected to the IDU via
the PTP 820F RJ-45 RFU interface. See
IDU-RFU Connection and Power Supply
Power Admin
field in the Radio Unit page is set to
Enable
. If PoE power is being supplied to the RFU, this default setting
should be kept. If power is being supplied to the RFU from an external power source, the
Power Admin
field
should be set to
Disable
to avoid unnecessary alarms.
•
Media Type
–
In System Release 10.0, you can use only one PTP 820F combo radio interface (RFU1), but you
can choose between the electrical (RJ-45) RFU1 interface or the optical SFP RFU1 interface. The
Media Type
parameter must match the interface type actually being used on the IDU. The default value is
RJ45
. If you are
using an SFP interface, you must set this parameter to
SFP
.
Note
The other radio interfaces on the PTP 820F are reserved for future use.
Figure 155
RFU1 Radio Interfaces on PTP 820F
To view or configure the PTP 820F
’s IDU
-RFU connection parameters:
1.
Select
Radio > Radio Unit
. The Radio Unit page opens.
Summary of Contents for PTP 820 Series
