Chapter 3: Configuration Guide
Configuring HSB Radio Protection
phn-3965_006v002
Page 3-108
11.
When you have finished configuring the 1+1 HSB group, unmute both radio carriers on both sides of the link.
See
Configuring the Radio Parameters
12.
Optionally, you can enable revertive mode so that following a switchover, the system initiates a revertive
protection switchover back to the original receiver once proper link and/or equipment conditions are
restored. See
Configuring 1+1 HSB with Space Diversity
1.
Create a Multi-Carrier ABC group with no members. For instructions, see
Configuring a Multi-Carrier ABC
2.
Enable protection for the Multi-Carrier ABC group:
i
Select
Radio > Groups > Multi Carrier ABC
. The Multi Carrier ABC page opens (
.
ii
Select the group in the Multi-Carrier ABC table and click
Edit Group
. The Multi Carrier ABC - Edit page
opens.
Figure 118
Multi Carrier ABC Group
–
Edit Page
–
Enabling Protection
iii
In the
Protection
field, select
Enable
.
iv
Click
Apply
, then
Close
.
3.
Create a 1+1 HSB-SD protection group:
i
Select
Radio > Groups > Radio Protection
. The Radio Protection page opens (
ii
Click
Create Group
. The Create Radio Protection Group page opens.
Summary of Contents for PTP 820 Series
