Chapter 3: Configuration Guide
Configuring HSB Radio Protection
phn-3965_006v002
Page 3-112
Figure 124
Radio Protection Groups
–
Edit Page (Copy to Mate)
1.
Click
Copy to Mate
. The configuration of the selected radio is copied to the other radio in the protected
pair.
2.
Click
Close
to close the Radio Protection Groups
–
Edit page.
Revertive Mode
When revertive mode is enabled, following a switchover the system initiates a revertive protection switchover
back to the original receiver ten minutes after proper link and/or equipment conditions are restored. This ensures
that the primary path is used whenever possible.
For HSB-SD groups, an additional revertive mode option enables you to configure revertive mode for diversity. If a
diversity switchover takes place and revertive mode is enabled for diversity, the system initiates a revertive
diversity switchover back to the original receiver ten minutes after a proper signal is restored on the primary
receiver.
To configure revertive mode:
1.
Select
Radio > Groups > Radio Protection
. The Radio Protection page opens (
2.
Select the protection group.
3.
Click
Edit
. The Radio Protection Groups - Edit page opens (
).
4.
In the
Revertive mode admin
field, select
Enable
to enable revertive protection or
Disable
to disable
revertive protection.
5.
In the
Revertive Rx mode admin
field, select
Enable
to enable revertive diversity or
Disable
to disable
revertive diversity.
Summary of Contents for PTP 820 Series
