Cambium Networks PTP 820 Series, User Manual, Page: 1057 / 1149

Chapter 24: Alarm Management and Troubleshooting (CLI) Performing Diagnostics (CLI)
phn-3965_006v002
Page 24-21
Adding Local and Remote MEPs (CLI)
To add a MEP, enter the following command in root view:
root> ethernet soam meg mep add meg-id <meg-id> mep-id <mep-id>
The following command adds MEP 25 on MEG 2.
root> ethernet soam meg mep add meg-id 2 mep-id 25
To remove a MEP, enter the following command in root view:
root> ethernet soam meg mep remove meg-id <meg-id> mep-id <mep-id>
The following command removes MEP 25 from MEG 2.
root> ethernet soam meg mep remove meg-id 2 mep-id 25
To display a list of all MEPs that belong to a specific MEG, enter the following command in root view:
root> ethernet soam meg mep show meg-id <meg-id>
Configuring the Local MEPs (CLI)
Once you have added local and remote MEPs, you must configure the MEPs and determine which are the local
MEPs.
To make a defined MEP a local MEP, you must assign the MEP to a service point on the Ethernet service on which
the MEG resides.
To assign a MEP to a service point, enter the following command in root view:
root> ethernet soam mep create meg-id <meg-id> mep-id <mep-id> sp-id <sp-
id> mep-dir <mep-dir>
The following command assigns MEP 35 on MEG 2 to Service Point 3 on the service on which MEG 2 resides.
root> ethernet soam mep create meg-id 2 mep-id 35 sp-id 3 mep-dir down
To change a MEP from a local to a remote MEP, enter the following command in root view:
root> ethernet soam mep delete meg-id <meg-id> mep-id <mep-id>
The following command changes MEP 35 from a local to a remote MEP.
root> ethernet soam mep delete meg-id 2 mep-id 35
To display a list of local MEPs for a specific MEG, enter the following command in root view:
root> ethernet soam meg local-mep show meg-id <meg-id>
For example: