Connecting 60 GHz cnWave™ Products
40
Connecting to the SFP+ optical module or SFP+ to copper
module to ODU
When ODU is powered through AC/DC PSU, an optical or copper Cat6A Ethernet interface can be
connected to the SFP port of the ODU for data interface.
Adapt the installation procedures in this section as appropriate for SFP interfaces, noting the following
differences from a PSU interface.
Connecting to the SFP+ optical module to ODU
Fitting the long cable gland
Optical SFP interface: Disassemble the long cable gland and thread its components over the LC connector
at the ODU end as shown below.
Copper Cat6a SFP interface : Disassemble the cable gland and thread its components over the RJ45
connector at the ODU end.
1. Disassemble the long cable gland used for optical SFP interface.
Disassemble the long cable gland used for copper SFP interface.
2. Thread each part onto the cable (the rubber bung is split).
3. Fit the parts into the body and lightly screw on the gland nut (do not tighten it).
Optical
Copper