cam SX50, Installation Operating And Maintenance Istructions, Page: 21 / 32

SPIRAL KNEADING MACHINE - SX / TXS / TSVX
Ed.
1/2012 Rev.0
-
21
ENG
Do not wash and/or clean:
I. by spraying water jets on the machine or its components;
II. by immersing the machine in liquids or detergents.
3.4 Regular maintenance
If the machine is used as prescribed and indicated in this manual, the adequate
manufacture of the mechanical pieces and the choice for suitable materials will allow the
machine to operate with no faults and no need for maintenance for many years.
Whenever regular maintenance operation is performed on the machine, make sure that
the machine is not connected to the mains (cable disconnected and green warning light
off).
3.5 Troubleshooting
Problem Probable cause Recommended solution
Machine does
not start
No power supply
I.
Check that the plug is properly
connected;
II.
check that the thermo-magnetic
switch has been activated (“ON”);
III.
verify that the differential switch
is active (if you press the “TEST”
button and the lever remains still
in high/upper position, this may
indicate that there is no power);
IV.
check if there is power in other
points close to the machine;
V. have the machine installed by a
duly trained technician.
Burnt fuses.
Short-circuit Lightning or sudden
change in voltage Have the machine installed by a duly
trained technician.
Trip operation
Clearance/abnormal
chain lengthening
Have the machine installed by a duly
trained technician.
In case of faults during operation, stop the machine, disconnect it
from the mains and immediately contact a specialized technician.