Pin layout for the lens iris output connector
No.
1
2
3
4
DC type lenses
Damping -
D
Drive +
Drive -
Rewire the lens iris plug
1. Cut off the plug of the lens cable, cut off approximately
8mm of the insulation, and then strip approximately
2mm of the ends of the cable sheaths.
2. Solder the ends of the cable wires to the ends of the
pins, and then attach the cover of the lens iris plug.
16
17
MOUNTING THE LENS
DAY&NIGHT FUNCTION SETTING
8mm
2mm
You can set the D&N function manually.
Day function
When you open the external S/W, the D&N function is
set to Day mode.
Night function
When you close the external S/W, the D&N function is set
to night mode.
Note :
If you use the external D&N function, you should set the
EXPOSURE /DAY&NIGHT option to EXT on the setup menu.
Open
External S/W
D&N
GND EXT
Close
External S/W
D&N
GND EXT