INSTALLATION DRAWINGS
▪
The minimum hood distance above cooktop must not be less
than 26” for an electric cooking surface and no less than
28"*
for a gas cooking surface.
*
Distances over 30" are at the installer’s and users’ discretion, providing that ceiling
height permits
.
ELECTRICAL INSTALLATION REQUIREMENTS
WARNING
THIS RANGE HOOD MUST BE PROPERLY GROUNDED. TURN OFF ELECTRICAL POWER AT SERVICE ENTRANCE BEFORE
WIRING. CHECK TO MAKE SURE THAT THE ELECTRIC CORD IS NOT IN CONTACT WITH THE SHARP EDGES OF THE
APPLIANCE.
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN IF THE
GROUNDING INSTRUCTIONS ARE NOT COMPLETELY UNDERSTOOD OR IF THERE IS DOUBT AS TO WHETHER THE
APPLIANCE IS PROPERLY GROUNDED. DO NOT USE AN EXTENSION CORD. IF THE POWER SUPPLY CORD IS TOO
SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN OUTLET NEAR THE APPLIANCE.
▪
This appliance must be
plugged into
an outlet that is properly installed and grounded. In the event
of an
electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire
for the
electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug.
▪
Position the outlet offset so that the power cord will not interfere with
the round
duct.
▪
Make sure this does not interfere with a
mounting area
.
LOCATION REQUIREMENTS
IMPORTANT
:
Observe the provisions of all applicable codes and regulations.
Refer the installation of the hood to a qualified installer. It is the installer's responsibility to respect the required
separation distances
.
Install the range hood away from any area exposed to drafts, such as windows, doors, and heating vents.
Observe the dimensions indicated for the opening to be cut in the cupboard. These dimensions take into account the
minimum values of separation clearances. Before cutting, also refer to the instructions on the cooktop or cooker,
above which you will place the hood.
The hood is factory-configured for installation with exterior discharge through the roof or wall.
Seal each opening cut in the ceiling or wall for the installation of the hood with duct tape.