12
Cooking with Dual Radiant Element
Dual Element can be operated using inner element only
or both elements.
To use inner element
1.
Depress
Element Size switch downward. Dual
Element switch is located on right side of control
panel next to surface element control knob.
LARGE
SMALL
Element Size Switch
2.
Push in and turn surface element control to desired
setting.
• Element will cycle on and off to maintain desired
heat setting.
Surface Element Control Knobs
3.
When finished cooking turn control to
OFF position.
To use both inner and outer element
1.
Depress
Element Size switch upward.
2.
Follow steps 2-3 above.
LARGE
SMALL
Element Size Switch
Operating Surface Elements
WARNING
!
To avoid risk of serious personal injury, property
damage, or fire, do not leave surface elements
unattended while in operation. Grease and spillovers
can ignite causing a fire.
1.
Push in and turn surface element control to desired
setting.
• Some ranges have two indicator lights, one for
elements on right side and one for elements on left
side of range. When either front or rear element is
on, corresponding indicator light glows.
• Some ranges have one indicator under clock.
When any element is on, indicator light glows.
• Smoothtop ranges can have one or two hot
indicator lights. After the surface controls are
turned off, the appropriate surface indicator light
will continue to glow until the surface elements
have cooled.
The length of time each light remains on will vary.
Do not expect the lights for two different heating
areas to go off at the same time even if the
elements were turned off simultaneously.
2.
When finished cooking, turn control to
OFF position.
Surface Element Control Knob
Surface Element Settings
LO—Use to prepare food at less than boiling temperatures
or to simmer.
MED—Use to maintain boiling of larger amounts of food,
low temperature frying and to maintain correct pressure
in a pressure cooker.
HI—Use to bring food to boiling temperatures. When food
is boiling temperature setting should be reduced to LO
through MED.
Using the Surface Elements
HI
OFF
LO
MED
HI
OFF
LO
MED