BIOHARMONEX 4.0
USER’S GUIDE
29
After the program is selected, set the start time according to the "Time Setting" section. To do this,
touch the button (00:00) to the left under the selected program name.
After setting the start time, select which days of the week you want the program to run automatically.
Select the program days by touching the small circles under the name of the program
.
Tap the days you want to autorun the program. The colors of the selected days change to blue. Finish
the setting by tapping the check mark on the left.
ATTENTION:
If you do not select any day, the program will not start!
The display shows a summary of the program name, start time, and selected days, indicated by small
blue circles.
To save the program, tap the icon on the left.
If you do not want to save your settings, you can delete them by tapping the icon.
ATTENTION!
All settings indicated above must be made for automatic running of a program. If
the autorun settings are incomplete, the program will not automatically run as planned. If, during
set up, you decide not to autorun the program, press the "X" button to cancel the process.
The BioHarmonex
is not designed to run two or more programs simultaneously. If you are setting a
program to run at the same day and time as another program that has been previously entered into the
automatic programming memory, the display will show the following message: ‘PROGRAM
COLLOSION’. After this message has been displayed, the device reverts to program summary allowing
you to change the starting time of the additional program you are trying to autorun.
The BioHarmonex
automatic programming memory can hold 30 different automatic settings. If the
memory capacity is full, a ‘MEMORY FULL’ message will appear on the display for 2 seconds, after
which the display will automatically revert to the “AUTORUN” menu. In this case, additional new
programs cannot be entered into the automatic programming, unless some of the programs previously
entered into the automatic programming memory are deleted.