Keep the wand and the cable uncovered until testing has been completed.
Gate Opener Wiring Diagram
Located on the right side of your gate opener circuit board, connect the wires on the exit wand
to the following terminals below.
Black wire
24V-COM
Red wire
24-VDC
Blue wire
Exit Loop
Green wire
24V-COM
Range Adjustment Board Connection (Optional)
Connect the YELLOW wire of the wand to the yellow wire of the range adjustment board.
Connect the GREEN wire of the range adjustment board to 24V-COM on the gate operator
circuit board.
Testing
Please make sure there are no moving metal objects within the range of the sensor when the
wand is first powered up and please wait 60 second for the wand to calibrate itself.
After installation and wiring, you must test the wand to see if it is working properly and see if
the range needs adjusting for optimal performance.
Cover the wand and the cable (PVC conduit) after testing is finished and everything is working
okay.
Troubleshooting
If the wand is not working:
Make sure all wired connections are correct.
Make sure the range adjustment is set at maximum range.
Disconnect the power to the wand.
Reconnect the power to the wand and make sure that no metal object or vehicle is
moving around the wand for 60 seconds while it is calibrating.
NOTE: The wand may sense a bicycle, tricycle, or other equipment that includes a mass of metal
that would activate the gate opener.
