• Remove your La Jolla from its protective packaging
and place on LEVEL SURFACE in the desired location.
To obtain proper water flow it is critical that the
La Jolla unit be placed on a LEVEL SURFACE.
• The Stainless Steel burner will be in place at the
top of the La Paz.
• If it has shifted in transportation be sure that the
burner is placed back into its original position.
•
Check to be sure that the burner is free of any
debris and water before using.
• Check all fittings to be sure that they are connected
and tightened appropriately.
• Check list:
• Connector hose is attached to the top side of the
integrated valve located in the side of your unit
and to the LP orifice located at the termination
of your burner.
• For LP connections the end of the hose with
regulator is connected to the LP gas supply
(tank) and the opposite end of hose is attached
to the bottom of the integrated valve.
• For Natural Gas installations:
• Replace the orifice that is installed in your burner
with the Natural Gas Orifice that is supplied in
your instruction envelope.
• Note: If you have a Natural Gas set up, you will
not use the hose with the regulator.
• Connect the natural gas supply to the open end of
your integrated valve. This can be accomplished
with a flex line which you will need to purchase.
• Check all connections for a gas leak by using a
soapy water spray. Bubbles will appear if a leak is
present. If bubbles appear, tighten the connection
and test the area again. Continue this process until
you are comfortable that there are no leaks present
in your gas supply system.
• Remove the rear door and place your LP tank inside
the La Jolla on the bottom of the base and attach
the LP hose with regulator.
• Your La Jolla firepit is match-lite and requires the
use of a long handle lighter.
• Load your burner with the supplied media (glass or
gas logs) before lighting.
• Light the long handle lighter and hold over the
firepit.
• Turn the gas on slowly to allow for a small fire upon
ignition. After ignition remove the long handle
lighter and adjust the flame to the desired height.
•
Excessive gas should not be used for lighting!!!!!!
Once you have completed the gas hook up portion
of the assembly, you are ready to go forward:
• Check to be sure that the water hose is connected
to both the pump and the outlet to the face of the
La Jolla.
• Place your pump into the water reservoir “kangaroo
pouch” located on the back side of the front wall.
• There is a recess at the bottom of the door opening
to allow the electric cord to be laid into it and the
door to be located in a secure fit.
• Fill the water reservoir with enough water to cover
the pump, but not so much for it to pour out of the
front crevice.
• Before plugging the pump into the electric outlet,
be sure to wet down the entire face of the La Jolla
to minimize the opportunity for water
to spill onto the floor surface.
• The water pump supplied with your
La Jolla allows you to adjust the
water flow, if necessary.
• Place the door in place and enjoy
your La Jolla.
La Jolla
Waterfall Firepit Series
Water Feature Fire Pit Set Up
w w w . c a l i f o r n i a o u t d o o r c o n c e p t s . c o m
5
