User Manual – Rev B
FCS Series II
3.5.3 Multi-chassis Output Wiring Diagram
Figure 3-2 through Figure 3-4 show the required output connections for FCS36/2 and FCS54/3
single and three phase multi-chassis systems respectively (rear-view perspective).
Always turn
off AC mains power to the FCS36/2 or FCS54/3 by turning off the circuit breakers on both
the Master and Auxiliary power source before making or changing output connections.
The terminal block shown to connect the outputs of both chassis together is provided in the
FCS36/2 or FCS54/3 ship kit. The System Interface cable is a DB25 to DB25 M/F cable
approximately 2 meters in length. (CI P/N 250778). This cable connects between the male DB25
connector on the Master unit rear panel labeled TO AUXILIARY INTERFACE and the female
DB25 connector on the Auxiliary unit rear panel labeled TO MASTER INTERFACE as shown in
Figure 3-2 through Figure 3-4. The OUTPUT SAFETY COVER must be removed to use the
System Interface and the AC Source must be installed in a cabinet with a protective rear screen
or door.
Figure 3-2: FCS36/2-3 Wiring diagram - Three Phase mode
California Instruments
33
Summary of Contents for FCS Series II
Page 4: ...User Manual Rev B FCS Series II California Instruments 4...
Page 27: ...User Manual Rev B FCS Series II California Instruments 27...
Page 89: ...FCS Series II 89 Figure 5 1 FCS System Block Diagram User Manual Rev B California Instruments...
Page 95: ...User Manual Rev B FCS Series II Figure 6 1 Calibration Setup California Instruments 95...
