User and Programming Manual – Rev P
California Instruments
14.4.6. *RST
This command resets the AC source to a setting defined by the values in the register defined
by PON if valid or by the following factory-defined states:
Table 13: *RST default parameter values
Item
Value
Item
Value
VOLT 0V
FREQ
60
HZ
CURR Note
VOLT:RANGe
136V
OUTP
0 (OFF)
DISP:MODE
0 (FREQ)
Note: For 1251RP: 9.2A For 801RP: 6A
Command Syntax
*RST
Parameters None
Related Commands
*SAV
Table 14: Status register power on condition
Register
Status on Power On
Status after *RST
- ESE register
All 0’s
All 0’s
- ESR register
PON bit = 1, all others 0
PON = 0, all others unaffected
- STB register
All 0’s
All 0’s
- SRE register
All 0’s
All 0’s
Note: Sending the *RST command will cause the unit to recall the REMOTE or LOCAL state
based on the setting of the SYSTem:KLOCk command. This may put the unit in local if this
state is set to 0. To avoid this, either set the SYSTem:KLOCk state to 1 or follow the *RST
command with a SYST:REM command. See SYSTem:KLOCk for information on the power
up remote / local state.
14.4.7. *SAV
This command stores the present state of the AC source to a specified location in memory.
Up to 8 states can be stored in nonvolatile memory.
Command Syntax
*SAV
Parameters
0 through 7
Related Commands
*RCL *RST
RP Series
October 2005
67
