INSTRUCTIONAL MANUAL
2750L-P/4500L-P/6000L-P
August, 2001
Rev. K
-71-
Table 3-16
CHANNEL DESIGNATORS AND NOUN MODIFIERS
CHANNEL
DESIGNATOR
MODIFIER
FUNCTION
:CH00
:CH01
:CH02
:CHO3
:CH00
:CH01
:CH02
:CH03
:CH00
:CH01
:CH02
:CH03
:CH00
:CH01
:CH02
:CH03
:CH00
:CH00
:CH01
:CH02
:CHO3
:CH00
:CH01
:CH02
:CH03
:CH00
:CH01
:CH02
:CH03
VOLT
VOLT
VOLT
VOLT
FREQ
FREQ
FREQ
FREQ
PANG
PANG
PANG
PANG
CURL
CURL
CURL
CURL
SYNI
POWR
POWR
POWR
POWR
APOW
APOW
APOW
APOW
CURR
CURR
CURR
CURR
Simultaneously set amplitude for Phase A, Phase B and Phase C
Set Phase A Amplitude
Set Phase B Amplitude
Set Phase C Amplitude
Set Frequency
Set Frequency
Set Frequency
Set Frequency
Syntax error with :CH00
Set Phase A phase angle
Set Phase B phase angle
Set Phase C phase angle
Simultaneously set Phase A, Phase B and Phase C current limit.
Set Phase A current limit
Set Phase B current limit
Set Phase C current limit
Set sync to external signal
Send power measurement data for Phase A, Phase B and Phase C to Bus
Controller
Send power measurement data for Phase A to Bus controller
Send power measurement data for Phase B to Bus Controller
Send power measurement data for Phase C to Bus Controller
Send apparent power measurement data for Phase A, Phase B and Phase
C to Bus Controller
Send apparent power measurement data for Phase A to Bus Controller
Send apparent power measurement data for Phase B to Bus controller
Send apparent power measurement data for Phase C to Bus Controller
Send output current measurement data for Phase A, Phase B and Phase
C to Bus Controller
Send output current measurement data for Phase A to Bus Controller
Send output current measurement data for Phase B to Bus Controller
Send output current measurement data for Phase C to Bus Controller
3.8.3.3
SRX and SRN OP-CODES
The SRX (set maximum) OP-code sets the maximum value of the programmable noun modifiers VOLT, FREQ, PANG
and CURL. It is always accompanied by a noun modifier. An example of setting the maximum output amplitude of all
phases to 135 volts and the output to 115 volts follows:
FNC ACS :CH00 SRX VOLT 135 SET VOLT 115.0 <CR> <LF>
The SRN OP-code sets the minimum value. For example, to set the minimum value of the output amplitude to 5.0 volts
and the output to 20 volts, the following string is transmitted:
FNC ACS :CH00 SRN VOLT 5 SET VOLT 20 <CR> <LF>
Summary of Contents for 12000L-1P
Page 119: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 115 Figure 6 1 MODULE LOCATION...
Page 138: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 134 Figure 14 EMERGENCY VOLTAGE...
Page 148: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 144 FIGURE 2...
