TH52D2-R_ii_161005
Pg 2
1
2
INSTALLING VALVE TO FRAME
Determine the desired location for the valve,
construct suitable stud, and support framing
Attach VALVE (1) to CROSS SUPPORT (2) by using
SCREWS (3) (not supplied) as shown
The valve should be level in HORIZONTAL,
VERTICAL and PARALLEL to wall
Placement of VALVE (1) and CROSS SUPPORT (2)
within the wall shall be determined by the MIN/MAX
Limits shown on MUDGUARD (4)
For complete detailed VALVE (1) dimensions see .
5
.
ROUGH-IN DIMENSIONS
WATER CONNECTIONS
Remove and discard THREAD PROTECTORS (5)
Pre-assemble FITTINGS (6) prior to attaching to
VALVE (1)
Apply thread sealant to all FITTING (6) threads and
attach to VALVE (1)
Attach “COLD” INLET to
COLD SUPPLY and “HOT” INLET to HOT
SUPPLY. All soldering of FITTINGS (6) shall be
performed a minimum of 4” away from
VALVE (1)
Perform all other required connections to output
device(s) (i.e. showerhead, handshower, etc.…)
Turn on water supply and check for leaks
IMPORTANT: Flush supply lines prior to installation to prevent
damage and malfunction of thermostatic cartridge.
IMPORTANT: Cold water supply must be connected to inlet marked
“COLD” and hot water supply must be connected to inlet marked
“HOT”.
CAUTION: This valve contains plastic and rubber components. Do
not sweat or braze directly to the valve body. Do not apply excessive
heat to the valve body when performing solder connections. Do not
apply flux or acids directly to the valve, as damage to the seals, plastic
components, and trim finish may result.
CAUTION: Inlet and outlet threaded joint connections should be
made with plumber’s PTFE tape or liquid sealant. Oil-based, non-setting
compounds should not be used.
WARNING: Forcibly rotating thermostatic cartridge stem prior to
installing handle trim, will damage cartridge and void warranty.
HOT
SUPPLY
COLD
SUPPLY
MIXED
OUT
MIXED
OUT
MIXED
OUT
