3
4
Compact Disc Operation
Power Supply
Battery Supply
• Open the battery compartment and insert 8 “C” cell batteries.
• Remove the batteries if exhausted or if the unit will not be used for a long period.
• The battery supply is switched off when the set is connected to the main.
• To change over to battery supply, pull the plug out from the AC socket.
Note on Environmental Protection
Do not throw exhausted batteries in the garbage. Hand them over instead to a recycling center or public collection point.
Go to pages 14 & 15 to read about safe listening with headphones.
Inserting a CD
• Set the Function switch to
CD.
• To open the
CD
compartment, lift the CD door on the edge marked
OPEN/CLOSE.
• Insert the
AUDIO CD
, printed side facing up.
• Close the cover.
• The CD-player scans the contents list of the CD, then the total number of tracks appears on the display.
Playing a CD
• Press
PLAY/PAUSE
to start playback.
• The display shows the track number.
• Adjust the sound using the
VOLUME
and
DBBS
controls.
• For brief interruptions, press
PLAY/PAUSE
– the “ ll “ appears on the display.
• To resume playback, press
PLAY/PAUSE
again.
• To stop playback, press
STOP.
– The total number of tracks will then appear on the display.
The CD player also goes to
STOP
position when:
• If the CD door is opened
• When the end of the CD is reached
• If the Function selector is changed
• If the batteries run down or if the power supply is interrupted.
• To take out the CD, open the CD door by lifting the edge marked
OPEN/CLOSE.
• Open the CD door only if the CD-player is in position STOP.
Selecting another track during play
• Press
PREVIOUS or NEXT
until the desired track number appears in the display.
• The selected track begins to play after
PLAY/PAUSE
is pressed.
Starting with a particular track
• Press
PREVIOUS or NEXT
until the required track number appears in the display.
• Press
PLAY/PAUSE.
• Play starts from the selected track.
Searching for a passage during a play
• Hold
PREVIOUS
down to search backwards to the beginning.
• Hold
NEXT
down to search forwards to the end.
Note:
This function can be described as “audibly” searching for a title. During the search, volume is reduced and returns to its
adjusted level as soon as the button is released.
Radio Reception
• Set the Function switch to
RADIO.
• Turn the tuning button until a radio station with sufficient signal strength is found. Repeat this procedure
until the desired station is reached.
• To tune into a weak station turn the tuning button until the display shows the desired frequency or when the best
reception has been obtained.
• Extend the telescope antenna and adjust for best reception.
• Adjust the sound using the
VOLUME
and
DBBS
controls.
• You can connect a stereo headphone with a 3.5mm plug to the jack. Note that inserting the plug automatically
disconnects the speakers.
• Select the wave band using the
BAND SELECT
selector.
• Tune to a desired radio station using the
TUNING control.
• The set is switched off when the Function switch is in the TAPE position and no button is pressed.
Recording from the Radio
• Insert a blank or pre-recorded tape into the cassette compartment.
• Set the Function selector to
RADIO.
• Select the wave band using the
BAND SELECT
switch.
• Tune to desired radio station using the
TUNING control.
• Start recording by pressing record of cassette deck.
Radio Operation
califone_1776_manual.indd 6-7
10/2/08 3:51:14 PM
