Caliber RMD 210, Instruction Manual

Page: 4 / 10

Page 3 Page 8
4.MUTE BUTTON
When the unit is powered on, press this button to switch the MUTE on/off.
5. LCD Display
6&7. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS
a) In RADIO mode:
Press the >>| or |<< button briefly to manually tune up/down for your desired
radio station step by step.
Press and hold the >>| or |<< button for more than 0.5 seconds to automatically
tune up/down for an available radio station of strong signal.
b) In SD/MMC & USB mode:
Press the >>| button briefly to play next track. Press the |<< button briefly to play
from the beginning of the current or previous track.
Press and hold the >>| or |<< button to skip forward or backward, release to
resume normal playback.
8. BAND & PTY (PROGRAM TYPE) BUTTON
During radio mode, press the BND button briefly to select the radio broadcasting
band you would like to hear. The AM/FM band is toggled cyclically through the
tuning bands: ->FM 1-> FM 2 -> FM 3 -> MW 1->MW 2 ->.
Press and hold the button to select one of the following mode:
POP M- - NEWS
While selecting PTY TYPE, its selection is implemented by preset buttons as
described in preset key. (press one of the 6 preset buttons shortly and repeatedly
to select the PTY TYPE in the preset button) When POP M or NEWS is on, the
previous PTY program and PTY icon is displayed on LCD. If there are no keys
entered for 2 seconds, previously selected PTY is searched. During 1 loop, if
desired PTY is not found, NO PTY is flashed, then returns to previous normal radio
and PTY icon disappear.
9. MODE BUTTON
Press it to select RADIO, CARD(after inserting an SD/MMC card), USB(after inserting
USB stick) and AUX mode.
10. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and then
returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 second until the real time
flashes on the display. Then you can adjust HOUR or MINUTE by rotating the VOL-
or VOL+ button .
11. TA [TRAFFIC ANNOUNCEMENT] BUTTON
When pressing the button, TA mode is switched on or off.
When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA
SEEK will be displayed on LCD for a while.
When traffic announcement is transmitted:
1). If the unit is in SD/MMC, USB mode, it will switch to radio mode temporarily.
2). If volume level is below 20, volume level is raised to 20, and returns to its previous
mode and volume level when the traffic announcement is over.
If volume is adjusted during traffic announcement, only the traffic announcement
volume is valid.
CONNECTOR A
1.
2.
3.
4. 12V
5. Auto Antenna Output
6.
7. 12V (To Ignition Key)
8. GROUND
CONNECTOR B
1. Rear Right Speaker (+)
2. Rear Right Speaker (-)
3. Front Right Speaker (+)
4. Front Right Speaker (-)
5. Front Left Speaker (+)
6. Front Left Speaker (-)
7. Rear Left Speaker (+)
8. Rear Left Speaker (-)
WIRES CONNECTION
ISO SOCKET SKETCH
F
U
S
E
1
0
A
ISO SOCKET
WHITE WHITE
RED
RCA LINE OUT
REAR RIGHT
REAR LEFT FRONT LEFT
FRONT RIGHT
RCA LINE OUT RCA LINE OUT
RCA LINE OUT
RED
ANTENNA JACK