adcv
r/o 0 65535
Raw ADC value
aout
r/o 0.0 .. 10.0
V
Analog output voltage
attn
0 10 20 30
dB
Attenuation
daco
-200 .. 0
dB
Analog output offset
dacs
-5.0 .. 5.0
V/dB Analog output scale
dflt
r/o OK FAULT
D/C supply fault
edge
0 .. 19000.000
MHz Band edge
fltr
0 0.1 0.5 1 5 10 50
100
Hz
Post detector filter
freq
depends
on
LO
settings
MHz RF receive frequency
lbfr
r/o 950 .. 2050
MHz L-Band receive frequency
levl
r/o -999.99 .. 0
dBm Beacon level
ln22
OFF ON AUTO
22kHz Tone
lnbv
OFF
14V
18V
AUTO
LNB voltage
lof1
-19000.000
..
19000.000
MHz Low band LO frequency (negative values indicate LO > RF
frequency)
lof2
-19000.000
..
19000.000
MHz High band LO frequency (negative values indicate LO > RF
frequency)
msbw
6 12 30 100
kHz
Measurement bandwidth
rxpl
H V
Polarisation
scmp
-10.0 .. + 10.0 dB
Spectrum compensation
sflt
r/o OK FAULT
Synth fault
srno
r/o character string
Device serial number
sver
r/o character string
Software version
temp
r/o -40 .. 120
°C
Temperature
tflt
r/o OK FAULT
Threshold fault
thrh
-999.99 .. 0
dBm Alarm threshold
3.5 Detailed parameter descriptions
The following paragraphs describe each remote control command parameter setting, grouped by category of
usage.
State and measurement values (read-only)
levl
(Receive level, dBm) This is the measured signal level at the receiver's L-band input.
adcv (Analog output voltage, V) This value shows the voltage the receiver actually outputs at it's
analog output port. Please note that the reading shown here is not calibrated to match the true
output voltage exactly.
temp (Board temperature, °C) The temperature shown is the temperature measured on the beacon
(C) 2020, SatService GmbH
www.satnms.com
LBRX-1MT-UM-2002 Page 13/21
