10
Installation /
Assemb
ly
2010 G Series Gas Grills
LTR50001050, Rev. B
www.calspas.com
On LP systems, remove the cylinder from the grill.
3.
Call an authorized gas appliance service technician or an LP gas
4.
dealer.
Do not use the appliance until the leak is corrected.
Installing the Grill in a Barbecue
Island
You will need a second person to help you to avoid damaging
the grill or your barbecue island.
Before installing a grill in any island or cut out, make sure that the
opening is not bigger than the outside frame of the grill unit. The grill
should rest on the lip of the frame.
Pay careful attention to the location of the gas line. It should be
routed away from sources of heat and should make as few bends as
possible.
Check to see if the gas line connection will be accessible when grill is
installed.
If the gas line connection is not easily accessible when the grill is
•
installed, support the grill above counter level and attach the gas
line to the grill. When the gas connection is made, slide the grill
into the cut out.
If the gas line connection is accessible when the grill is installed,
•
slide the grill into the cut out and then attach the gas line.
Be very careful not to kink the gas line when lowering the grill into the
cut out.
Keep your fingers away from where the grill will be supported on
counter. Your fingers could become trapped and serious injury could
occur.
Check to make sure the grill is level and is supported around the entire
outside edge. If the grill is not level or is unstable, use non-combustible
shims under the outside lip to stabilize it.
Perform the leak test procedure as described earlier in this manual.