4
6. The Backpack straps can now be installed. To do this, pass the looped end under the cross bar on the back
of the chair. Wrapping the clip end around the bar, pull it through the loop and pull it tightly as shown. Then
attach the clip to the Hook assembled to the cross bar. Photo 6a-c
5. Remove the 4 Cap Screws from the Bottom of the Chair Seat Assembly, and using the same screws, attach the
Leg Assembly as shown. Then firmly tighten the screws using the hex key provided. Photo 5a and b
Photo 5a
Photo 5b
Photo 6a
Photo 6b
Photo 6c
Photo 4a
Photo 4b
NOTE: These screws only need to be lightly tightened. Over-tightening the screws could
damage the Bar Holder. If having trouble aligning screw holes pull Rubber Bar Holders.
4. Using a screwdriver, remove the 4 screws in the Chair Seat Assembly shown. Then using the same screws and
washers, attach the two Rubber Bar Holders as shown. Photo 4a and b
