CalderaSpas PLT1S1001 Owner'S Manual Download Page 18

Page: 18 / 40

CONTROl OPERATION

Your control panel consists of an LED display and convenient touch pads that allow you to set the water

temperature and adjust the skim/filter cycle settings, lock spa temp, lock entire spa functions, as well as

control the hydrotherapy jets, and lights from spa-side.

lEd dISPlAY

The LED display on your spa-side control panel continually shows the spa’s actual water

temperature. In certain situations, it will also display other messages. See TROUBLESHOOTING

section.

TEMPERATURE CONTROl

The set temperature range is from 80°F (26°C) to 104°F (40°C).
The factory-set temperature is 100°F (38°C). Whenever power is

disconnected and then reconnected to the spa, the water temperature will

automatically seek the last set temperature.
Pressing the “

TeMP



” button displays the spa’s set temperature. To increase the set temperature, press the “

TeMP



”button again,

once for each degree of increased temperature desired. If you hold the button down, the set temperature will increase by one degree every half second. When

the set temperature has been reached, the “READY” icon will display.
Pressing the “

TeMP

▼” button displays the spa’s set temperature. To decrease the set temperature, press the “

TeMP

▼” button again, once for each degree

of decreased temperature desired. If you hold the button down, the set temperature will decrease by one degree every half second. When the spa water has

reached the set temperature, the “READY” icon will display.

JET PUMP CONTROl

Pressing the “JETS” button changes the jet pump functions, depending on the number of presses:

PalaTINO

MarINO

VaNTO

Spa Models only:

1st press:

System 1 jet pump runs on low speed

2nd press:

System 1 jet pump runs on high speed

3rd press:

System 1 & System 2 jet pumps run on high speed

4th press:

System 2 jet pump runs on high speed

5th press:

Both Systems jet pumps are off

TarINO

aVeNTINe

Spa Model only:

1st press:

System 1 jet pump runs on low speed

2nd press:

System 1 jet pump runs on high speed

3rd press:

Jet pump off

• The pump on high speed automatically turns off after operating for one hour. The pump on low speed automatically turns off after operating for one hour.
• When the jets are active, the JETS icon on the control panel will illuminate.

lIghT ON/OFF & INTENSITY CONTROlS

The light control uses four positions: High, Medium, Low, and Off. To turn on the spa light, press the LIGHT button. This will place all lights in the spa in the

High, or maximum intensity position. When the lights turn on, the light symbol will also illuminate on the control panel display. Press the LIGHT button again

to lower the intensity of the lights to the Medium position. Press the LIGHT button again to lower the intensity even more, placing the lights intensity in the

Low position. Press the LIGHT button one more time to shut the lights off. When the light is deactivated, the light symbol will also turn off.

If the lights are left on, they will automatically be turned off by the control system after 6 hours of continuous operation. The light symbol on the panel will also turn off

when the lights are deactivated.
If the lights will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on the control panel (see following pages for more information on

SPA LOCK).

OPeraTING INSTrUCTIONS

Display

Jets Button

Light Button

Temperature Down

Temperature Up

Set Button

SET

READY

F1
F2

READY