Page 9
Locate the two buttons below the
front panel.
Push up and hold one of the
buttons using an Allen wrench less
than ¼" (6 mm) in width or small
screwdriver into the center of the
safety lock then pull the door panel
slightly away from the spa next to
that button location to completely
disengage the bottom clip. Repeat
procedure on second button.
1
1a Push Button
then pull panel
1b Push
Button then
pull panel
Main Control Panel
Safety Lock
2a Pull
2b Pull
2
Pull (with slight force) on bottom left corner until panel
un-clips followed by the right corner until panel un-clips.
Clip
Clip
Clip
3a Light connector-
Turn and pull to
remove
3b Logo Light
connector- Push in
side clips and pull to
remove
3
Pull bottom door panel away (using
both hands spaced shoulder length
apart) from each side of the spa center,
this may require a slight amount of
force because of the upper clips until
they all un-clip. Lower panel to ground.
Disconnect both the logo light and front
light wires from door panel, then remove
door panel from spa area and set in a
cool shaded place. Remove foam to
access.
Backside of door panel
NOTE
: To replace the Door Panel see Door Panel
Replacement page in the Owner's Manual.
DOOR PANEL REMOVAL
