x
20
lINA
™
SPA MOdEl ONlY:
1st press:
Two-speed jet pump runs on low speed
2nd press:
Two-speed jet pump runs on high speed
3rd press:
Jet pump off
• During filter cycles or when the thermostat is calling for heat, the pump’s low speed operates automatically and cannot be turned off by pressing the
Up (
5
)
or
Down (
6
)
touch pad.
• The pump on high speed automatically turns off after operating for two hours. The pump on low speed automatically turns off after operating for two hours.
• When the jets are active, the JETS icon on the control panel will illuminate.
lIghT CONTROl
The Cima
TM
and Lina
TM
spas are equipped with a low-voltage spa light. Press the "LIGHT" button to turn it on. Press it a second time to turn it off.
The light automatically turns off after six hours.
When the light is active, the LIGHT LED on the control panel will illuminate.
FIlTER CYClES
Your spa will automatically turn the filter cycle on twice each day. When the spa is first powered up the automatic filter cycle will wait 12 hours before starting. A one hour
filter cycle using the low speed of the jet pump is the programmed default filter cycle time. The filter cycle occurs twice a day (every 12 hours).
To modify the length of the filter cycle:
A. Press and hold the "
LIGHT" button for approximately five seconds until the display shows "xx" where xx is a number from 0-12. This is the length of the filter time.
B. Using
Up (
5
)
or
Down (
6
)
, adjust the value as desired.
C. Pressing the "LIGHT" button again confirms the setting and starts a cycle immediately.
D. If the "LIGHT" button is not pressed again, the new filter time is stored, but the cycle is started at the next scheduled time.
The filter cycle will activate the jet pump on low speed for the entire cycle. When activated, the filter cycle LED on the display is turned on. If the temperature exceeds
the set point by 3º F (1.5º C) for more than three hours, the system will cancel the FILTER cycle and the FILTER LED will blink for the remaining filter cycle time. Should
the temperature cool down to 2º F (1.1º C) below the set point before the end of the cycle, the cycle will resume for the rest of the time. Should you use the spa during
the filter cycle by placing the jet pump on high speed, the FILTER LED will blink. Once the jet pump has been shut off, a ten minute tranquil mode begins (FILTER LED
will be blinking during tranquil mode) before the filter cycle will resume. The blinking filter LED indicates that the filter cycle timer is still counting, but the cycle has been
temporarily interrupted.
NOTE:
The interrupted time of a filter cycle is not extended after the filter cycle resumes. Power interruptions of the spa will reset the filter cycle to the default one hour
cycle time and begin 12 hours after spa regains power.
OPERATING INSTRUCTIONS
Summary of Contents for Caldera Spa Vacanza Series
Page 1: ......
