Caldera Vacanza Series, Pre-Delivery Instructions

Page: 10 / 16

The TARINO and AVENTINE spa comes equipped with approximately 15 feet of usable power cord (this is the
maximum length allowed by regulatory standards and the National Electric Code). The power cord is wrapped in
bubble packaging for shipping and can be found inside the skirt. Remove the bubble wrap and roll the cord out to
the desired length.
230 v
olt
e
lectrIcal
r
equIrements
To ensure you will have an opportunity to use your spa soon after delivery, it is very important that the required
electrical service has been installed. Unless otherwise stipulated by your dealer, THIS IS YOUR RESPONSIBILITY .
IMPORTANT : All electrical circuits must be installed by a qualified, licensed electrician. The equipment pack requires
a MINIMUM of 112 volts per line under load.
CONTROL BOX
PANEL
ELECTRICAL
MAIN SERVICE
LESS THAN 100 FT.
#8 AWG RED, L2
#8 AWG BLACK, L1
#8 AWG GREEN, GROUND
#8 AWG WHITE, NEUTRAL
50A
WITHIN SIGHT OF THE SPA
THE SUB-PANEL MUST BE
MORE THAN 5 FEET
DO NOT EXCEED 50 FEET
WITH GFCI
BREAKERS
50A
SUB-PANEL
L2
GRD
L2, HOT, #8 AWG RED
L1, HOT, #8 AWG BLACK
GROUND, #8 AWG GREEN*
N, NEUTRAL, #8 AWG WHITE
L1
L2
N
PERMANENTLY CONNECTED
230 VAC, 50A, 60Hz, MODELS 230VAC, 50 Amp
2-POLE
CIRCUIT BREAKER
(NON GFCI) N
L1
GN
D
ILLUSTRATION
SEE WIRING
230 VAC PERMANENTLY CONNECTED SPA
L1
L2
N
CONVERTED 230VAC SPA MODELS
JUMPERS REQUIRED
NO POWER
JP1 JP2 JP6 JP3 JP4 JP5 JP8 JP7
See
Owner’s Manual
for Spa Wiring
and Jumper
Configuration
Page 10
Pre-Delivery Instructions
CAUTIONS
USE COPPER CONDUCTORS ONLY
USE SUPPLY WIRES SUITABLE FOR
75°C/167°F.
DISCONNECT ALL SUPPLY CONNECTIONS
BEFORE SERVICING.
CONNECT ONLY TO A CIRCUIT
PROTECTED BY A CLASS A GROUND-
FAULT INTERRUPTER.
THESE SPAS ARE INTENDED FOR USE WITH
GFCI SUBPANEL
ALL CANADIAN SPA MODELS USE #8 AWG
GREEN, GROUND.
INCORRECT WIRING WILL DAMAGE CIRCUIT
BOARDS.
REFER TO THE WIRING INSTRUCTIONS
INCLUDED WITH THE SUB-PANEL FOR
DETAILED WIRING INSTRUCTIONS.