4
White
Side Spring
½” Plastic
Standoff
A
TTACH
S
PRING TO
H
OLDER
Push the spring [23] into the groove on the plastic holder [22].
Make sure that the first coil sits into the angled groove. This allows
the spring to sit flat on the bottom plate. If the spring coil is not
properly seated in the groove, the spring will sit on an angle and
make the car difficult to tweak properly.
Bag 4
23
23
25
22
4-40 x 3/8”
Button Head
24
Tweak Plates
Assemble the Tweak Plates
1 - Use the 3/8” button head screws [24] to fasten the plastic standoffs [25] to the
graphite tweak plate [20].
2 - Slide the 1/4” button head screws [26] up through the tweak plate [20] and
tighten a red low-profile ball [11] to the screw as shown in the illustration. Make
sure to use the forward hole on the tweak plate. The body mounts will go in the
rear hole in a later step.
3 - Slide the 1/4” flat head screws [27] up through the chassis and thread into the
plastic standoffs [25].
Make sure spring coil
is seated into groove
on spring holder.
24
25
11
4-40 x 1/4”
Button Head
26
Red Low-
Profile Ball
11
26
4-40 x 1/4”
Flat Head
27
1 - Install the black 2-56 ballstuds [28] into the graphite top plate [29]. These steel balls thread into the
graphite. Be sure to start them straight and square and turn them in slowly so they do not strip or break.
2 - Push the red ballstud [30] through the graphite top plate. Use a red locknut [9] to secure it. Attach the
assembled top plate to the Pod Plates using 3 3/16” button head screws [31].
2-56 Steel
Ballstud - Black
28
Red Alum
4-40 Ballstud
30
Red Locknut
9
27
9
28
30
31
29
4-40 x 3/16”
Button Head
31
