6
Bag 6
Battery Top Deck
Red 3/4”
Standoff
37
1 - Bolt the 3/4” hex standoffs [37] to the chassis using four 1/4” flat head screws [22].
2 - Mount the plastic battery blocker pieces [38] to the chassis by fitting them into the holes as shown below, and then secure in place with 1/4” FH screws
[22] in the center hole.
*Battery Positions - In the diagram on the top right, you will see that there are 3 positions for the battery blockers on the Gen-X10 LE chassis when using a
1S battery pack. In position 3, there is no rear blocker as the pack will rest up against the center pivot. There is also a 4th position for a 1S LiPo pack where
the pack goes across the back of the chassis like the Gen-XL 12th scale car. For this position, you will remove the top deck and battery blockers completely
(pictured on the bottom of the next page) and tape the battery in between the links. As shown below, there is only one position available for 2S packs.
22
37
4-40 x 1/4”
Flat Head
22
4-40 x 1/4”
Button Head
18
18
39
Red Low-
Profile Ball
12
12
4-40 x 3/8”
Flat Head
41
40
41
22
Insert the antenna tube (not pictured) into the front hole of the
antenna mount [40] and lock it in place using the 1/8” set screw [105].
You can wrap the antenna around the tube and hold it in place with
the antenna cap, or you can drill a hole in the mount above the 3/8”
FH screw [41] so you can feed the wire up through the tube.
22
38
(1S - 3)
(1S - 1)
(1S - 2)
(2S position)
3 - Mount the red low-profile ball [12] to the graphite top deck [39] in
the hole shown below using a 1/4” FH screw [22]. Then mount the
antenna mount [40] in the holes shown using the 3/8” FH screws
[38]. (The antenna mount [40], the 3/8” FH screws [38], and the 1/8”
set screw [105] come out of Bag 7, which is the next bag we will
open for assembling the center shock.)
4 - Once the top deck assembly is complete, mount the top deck [39]
to the chassis standoffs [37] using the four 1/4” BH screws [18].
