10
41
79
81
Installing the Lower arm to the Chassis
1 - Insert four 4-40 x 3/8” FH screws [41] through the chassis, and
then place two #4 washers [81] over each of the screws before
sliding them through the Front End Plate [79]. Secure these parts
with red locknuts [9].
2 - Now, secure the front end assembly to the plate using the 8-32 x
5/8” low head front end screws [80]. We recommend starting in the
rear hole, as this is the smoother setting. Going longer in the front
end will make the car steer more. Make sure you are using the same
set of holes for both sides!
CRC Pro-Strut
Front End - cont.
Red Locknut
9
8-32 x 5/8”
Low Head
F.E. Screw
80
Installing the Bumper to the Chassis
1 - Insert three 4-40 x 5/16” red FH screws [82] through the
chassis, then through the Bumper [83] Secure these parts
with three red locknuts [9].
9
4-40 x 3/8”
Flat Head
41
Gray #4 Washer
81
80
82
9
4-40 x 5/16”
Red FH
82
83