CalAmp | LMU-30xx/CVF-3030 & OBD-II Extender Cable Install Guide
Page 12
MBUD-0268v1.4
The orange light takes approximately 45 seconds to go from a blinking state to a solid state. A solid
orange light indicates a cellular connection.
The green light takes approximately 15-45 seconds to go from a blinking state to a solid state. A solid
green light indicates the device established a GPS connection.
If the green light continues to blink, move the vehicle to an area with better coverage (e.g., outside
of a garage).
The red light displays as soon as the vehicle has an ignition on event. The red light indicates the
device is receiving engine RPM data from the vehicle bus, which indicates successful communication
with the OBD-II port.
When all 3 LEDs on the LMU-3000 are locked solid, the installation is successful.
Figure 11: Secure the Extra OBD-II Extender Cable
9.
After verifying successful device installation, coil and secure with a zip-tie the extra OBD-II Extender
Cable to ensure it is out of the way of normal vehicle operations.
Figure 12: Tuck LMU-30xx/CVF-3030 Behind Panel
10.
Place your fingers behind the dashboard panel, and place a male-side (hook-side) piece of Velcro on
the flat section of the panel.
11.
Gently place the connected LMU-30xx/CVF-3030 device behind the dashboard panel and secure by
attaching the Velcro hooks and loops together.
