IT6860B User manual
用户使用手册
18
Enter
button to confirm.
5.4 Current setting
IT6860B series power supply enables customer to set current from 0V to rated value. Press
I-set
I-set
button, it will be lit. Now, there are three ways to set the voltage:
Solution1
: press
I-set
I-set
button-------press
button to adjust the cursor’s
position--------press
and
button to increase or decrease the setting value.
Solution2
: press
I-set
I-set
button------press
button to adjust the cursor’s
position------adjust the knob to increase or decrease the setting value.
Solution3
: press
I-set
I-set
number
0
to
9
to set the voltage value. Then press
Enter
button to confirm.
5.5 Output on/off
On/Off
button is used to control the output of power supply. When
On/Off
button is lit, it
represents output has been turned on. If
On/Off
button is dark, it indicates that ouput is off.
In output on mode, the indicator light CV or CC will be lit.
Note
: Please ensure the power supply and determinand has been connected well and then
press
On/Off
button to turn on the output.
5.6 switch the actual/setting value display
Meter
Meter
button is used to switch the display between actual and setting value.
(1) When
Meter
Meter
button is lit, it shows actual voltage and current on front panel. Meanwhile,
VFD will appear a marker of “meter”.
(2) When
Meter
Meter
button is dark, it shows setting voltage and current on front panel.
5.7 CC/CV mode
According the ohm’s law, output current is determined by output voltage and the resistance
of load. When actual current is less than the setting value, power supply will function in CV
mode. And CV status indicator lamp will be lit.
If actual current is above the setting value or rated value, power supply will change to CC
mode, and CC status indicator lamp will be lit.
5.8 Save/Recall
IT6860B series power supply enables customer to store up to 9*8 groups of different
operating parameters in a non-volatile memory.
Each operating parameters includes a constant voltage value, constant current value and
OVP setting value.
You can save or recall parameters by (Shift) +
Recall
(Save)buttons directly from the front
panel or through command *SAV,*RCL.
