Cairn FuraLED Quick Start Download Page 4

Page: 4 / 4

Q u i c k S t a r t

Focus and align the transmitted LED

Loosen the blue thumb screw which locks off the

transmitted LED focus adjustment

and

slide the LED head in Z within the coupling until the image of the LED comes into sharp

focus on the piece of paper (or centering tool). Lock off this position by

securing the thumb screw. A notch is present in the LED housing to help locate this

lock off screw and prevent the LED being fully pulled out of the coupling.

Adjust the position of the transmitted LED using the

transmitted LED X and Y adjustment

thumb screws until centred.

Please contact us if you have any questions or issues during setup or operation

Summary of Contents for FuraLED

Page 1: ...the two wavelengths Each LED has individual focus Z and XY adjustments to optimise output when connected to your micro scope This short guide details how to align your FuraLED coupling For general po...

Page 2: ...W POWER a Move to a blank objective position on the objective nosepiece remove any cover caps and place a small piece of white paper in this position Alternatively place a centering tool in the light...

Page 3: ...nd X Y Z adjustments for the transmitted channel W White 340nm 385 nm Transmitted LED X Y adjustments Transmitted LED focus adjustment FuraLED horizontal adjustment FuraLED vertical adjustment 1 Align...

Page 4: ...the piece of paper or centering tool Lock off this position by securing the thumb screw A notch is present in the LED housing to help locate this lock off screw and prevent the LED being fully pulled...