- 7 -
To remind before the installation
You have to keep in mind that :
Before the installation :
Have You cut the garden before the installation, especially the edges?
Is there a socket preferably in the widest area?
How wide is the garden? check the model specification and the batteries
provided
During the installation
Put the robot into charge on “PAUSE” modality.
Check the slides, by trying the robot with the option No Border.
Secondary areas. We manage the main area and three secondary areas.
(according to models)
Decide where to install the recharging base
-
“Preferred” Widest area but not compulsory.
-
Socket
-
Flat area
-
Water system
Check the water systems position.
At the end of the installation
Settle the rain sensor
Test how the robot follows the border cable
•
(With the key– Switch the blade off)
Test the recognition of the arrows.
●
(With not too charged batteries)
●
With the key “CHARGE” you simulate low batteries.
Program the working times of the Robot. (Pay attention to the working times
of the irrigators).
Inform the customer that he has to set out a password.
Leave the blade at 5-6 Cm and inform the customer that he has to lower it
when the border cable has been absorbed.
Hooked wheels (if the model robot allows this). It would be helpful not to
install them until the border cable has been absorbed by the ground.
