Caffitaly System S33, Instruction Manual

Page: 9 / 12

9
Descaling
Descaling signal : when the indicator light D blinks YELLOW and the machine 3 times, it is
advisable to do a descaling cycle, as illustrated below.
The machine has an advanced program that checks how much water is used to
dispense products. This measurement allows the user to know when the machine
needs a descaling cycle.
Make sure to use Caffitaly System descaler, which is designed to respect the machine’s
technical characteristics, in full compliance with consumer safety. The descaler must
be disposed of according to the manufacturer’s instructions and/or the regulations in
force in the country of use.
CAREFULLY read the directions for use on the descaler package. Avoid contact
with eyes, skin and machine surfaces.
Do not turn the machine off and do not raise the lever during descaling. A person
must be present during the operation.
Do not use vinegar: it could damage your machine!
• Switch the machine off by unplugging it (Fig.13).
• Empty and rinse out the used capsule drawer and drip-tray (Fig.6).
• Remove and empty the water tank (Fig.5).
• Mix half the contents of a bottle of Caffitaly System descaler with about 500ml of water
(total 625ml) and pour into the tank.
• Make sure the lever is lowered (Fig.3) and that no capsule is inside the capsule
compartment.
• Remove the drip-tray and place a container (at least 250ml) under the dispenser (Fig.9).
• Hold down the buttons A and B and at the same time plug the appliance in to switch it
on. The button B is lit up, whereas the indicator D blinks YELLOW and RED alternately.
• Press the button B to start the descaling cycle.
• The machine dispenses the descaling solution at intervals ( 5 dispensings with a
4-minute pause between each, for a duration of about 20 minutes ). During this
phase, when the buttons must not be pressed , the indicator light D blinks YELLOW
and RED alternately.
• If the container fills up, empty it.
• At the end of the first phase, the button B lights up and the machine beeps. The water
tank is empty.
• Carefully rinse out the water tank and refill it with fresh water (Fig.4).
• Empty and rinse out the used capsule drawer and the container used, and put them back
in place.
• Press the button B to start the rinse cycle.
• The machine dispenses the rinse water at intervals (2 dispensings with a 1-minute pause
between each. Approx. 500ml). During this phase the indicator light D blinks YELLOW
and RED alternately.
• When the rinse cycle is completed, the machine beeps and the buttons A- B-C blink
simultaneously, the machine is in the warming up phase
• When the buttons light up steady, the appliance is ready to use.
• Carefully empty and rinse out the water tank and refill it with fresh non-carbonated water
(Fig.4).
• Empty and rinse out the used capsule drawer and refit it together with the drip-tray.
English