5
III. Only heating separately, without frothing.
1. Place the appliance on a
fl
at surface.
2. Select mixing paddle according to your task. Then open the lid, insert the mixing paddle
onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk, observing
fi
ll lines and replace the lid.
Note
:
the max milk quantity permitted to add is 200ml, to avoid milk over
fl
owing after mixing
or frothing
.
4. Place the jar on the power base and connect the plug into a power outlet. The indicator
light will illuminate red.
5. Press the power button twice continuously within 2 seconds, the indicator light will turn
blue. Then the appliance will start to work. Once the temperature of milk has achieved
approximately 68 degrees, the heating element will stop heating and the mixing
paddle will stop rotating automatically; the indicator light will illuminate red again until
unplugging the power outlet.
Note
:
The rotation of mixing paddle is only used for avoiding sticking. It will not froth the
milk.
6. When the appliance has stopped operating, pour out the warm milk and enjoy it.
Caution
: A minimum of 3 minutes rest time must be maintained between cycles. Otherwise
after 5 continuos cycles continuously the appliance will enter self protection mode. When
this occurs, the indicator light will illuminate and
fl
ash blue. In addition the power button will
not be activated.
After Approximately 5 minutes the appliance will enter standby mode and the machine is
then ready for use.
7. Always turn off the milk frother and disconnect the power supply when not use.
Cleaning and maintenance
Always disconnect the appliance from the power outlet and allow it cooling down before
cleaning.
Caution
: Never immerse the jar, power base in water, or allow moisture to contact with
these parts.
1. Wash lid with water and mild detergent. (The lid is not dishwasher safe component)
Rinse thoroughly and dry.
2. Remove the mixing paddle and/or frothing paddle, and wash them completely in warm
water.
3. Wash the inner of jar with a combination of a mild detergent and water and then wipe
clean with a soft damp cloth.
4. Wipe the appearance of jar with a soft damp cloth or cleaner, never use a poisonous
cleaner.
Note
: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the
appliance to prevent the loss of the gloss appearance.
English
Summary of Contents for F02MK
Page 7: ...7 English...
